ESD PET Adhesive Film

Polstar-EWF is a good choice to make ESD surface economically by simply attaching

high quality ESD treated adhesive lm on the surface, like glass, acrylic, PC, etc. This lm

can also be used as a protection lm for protecting the surfaces or

devices from scratches during handlings, transportation, etc.

How to apply the lm on the surface eectively

1. Keep the surface free of dust, dirts, moisture, etc.

2. Measure the area where the lm is applied and cut the lm with extra 1-3 cm.

3. Prepare spray bottle with purity water mixing water-soluble detergent, like shampoo(8-10 drops of detergent for 1 litter water).

4. Spray the prepared water on the surface to make the surface wet and slippery.

3. Remove the releasing sheet from the lm and also spray the water on the adhesive area of the lm.

4. Attach the lm on the surface from the center of the area and press the lm out from the center to edge sides smoothly several

times by using of a at and soft scoop until the moisture and the air bubbles are completely removed.

6. Cut the lm tting in the surface perfectly.

* Please do not press or wipe edge side strongly until the margin of the lm is cut-o

* Please do not use any kinds of chemicals and solvents for cleaning.

* Use very soft wiper with water soluble detergent for surface cleaning.

Good ESD properties on backing side.

Semi-permanent ESD properties.

No migration.

Very low removal adhesive.